I discovered 3D printing over the winter and wanted to share with the community.
Had a buddy print the following;
One fixed the throttle slop on my 690, the other fixed a broken buckle on my leatt knee guards.
Cost $1 in material to make both.
Use cases are a bit limited, but there is an application for gear, buckles, boot straps, mounts etc...
Had a buddy print the following;
2020 KTM 690 Enduro R throttle slop remover by blalor
The ride-by-wire throttle on the 2020 KTM 690 Enduro R has some play in it, a bit of slop when closed that I didn't like. This pair of spacers removes that. Note that there are two different spacers; you must print the pair.
www.thingiverse.com
Replacement clip for Leatt dual axis knee guards by buckykat
This is a replacement clip for the Leatt dual axis knee guards. Just needs an M4x8 screw. If you want to be fancy, drop it in hot water for a few seconds and form it to the shape of the guards.
www.thingiverse.com
One fixed the throttle slop on my 690, the other fixed a broken buckle on my leatt knee guards.
Cost $1 in material to make both.
Use cases are a bit limited, but there is an application for gear, buckles, boot straps, mounts etc...